1
0:00:13,000 --> 0:00:16,000
(ENGINEER DUDE) O! Pip and Piperbot are 
about to use the Color Sensor!

2
0:00:16,000 --> 0:00:23,000
I hope they remember what I taught them about how 
to connect their sensors. Maybe they need a refresher. 

3
0:00:23,000 --> 0:00:29,000
(ENGINEER DUDE) These sensors are helpful tools, but 
there are some things to keep in mind while you are
connecting them to your Raspberry Pi.

4
0:00:29,000 --> 0:00:41,000
To connect the sensor to the Raspberry Pi, we need to
use the 4-Pin Diode Jumper Cable from the Sensor
Explorer box.  This cable is designed to keep you safe
as you wire up the sensors.

5
0:00:41,000 --> 0:00:47,000 
To wire up a sensor, we need to connect wires to 
power and ground pins on the Raspberry Pi.

6
0:00:47,000  --> 0:00:57,000
Now, normally, switching power and ground wires to
connect the sensor can cause problems. It could
overheat the sensor, damage  the Raspberry Pi, or
even the power bank.

7
0:00:57,000  --> 0:01:05,000
With the 4-Pin Diode Jumper Cable, current heading in
the wrong direction is blocked so that the current
can’t flow! This should keep you safe.

8
0:01:05,000  --> 0:01:08,000
(ENGINEER DUDE) And... that’s what I taught them.

9
0:01:08,000  --> 0:01:11,000
I really hope they remember!